6/11/2023 0 Comments Lightkey extension tutorialYou can use something like 255.255.255.0 which will tell your units that it needs to just look for any changes in the last number and the first 3 numbers will be the same. Then, you will need to set the Subnet Mask. If you’re not working with a Router you will need to set an IP Address (exp. Just note that not everything will have the option to work with ArtNet and sCAN so be sure to check this beforehand. You’ll also set up the Universes you want to Output and set whether you are using ArtNet or sCAN. Once you locate the configuration page you’ll want to set the IP Address. Go to your console, controller, or media server and see if it has a page for configuration. Now, it’s time to make it all come together and work. Some fixtures allow you to daisy-chain the ethernet signal similar to how you would daisy-chain a DMX signal.īut as always be sure to check the manuals and see what your options are, and understand that a large number of fixtures chained together can create some delay problems. Something to note and keep in mind is that a network switch may not always be needed. Then, from the network switch, your devices would be wired to the switch. In order to set this up, you would connect your computer or console to the network switch. If you’re working with more devices or plan on working with more devices in the future there are some additional steps for setting up.Ī network switch gives you the capability to connect multiple devices. In some cases, however, you might need a crossover cable, but just be sure to check your manual and see if anything like that would be needed. With most units, you can just connect the two devices together and have no issues. Next, you will need a Network Cable to connect the two devices. The second device would most likely be a DMX Node, LED Fixture, Moving Light, etc. In most cases, the first device will be a controller, a lighting console, or a media controller. If you’re just starting out it’s most likely that you’re looking to connect two sACN or Art-Net devices. In this post, I am going to teach you the basics you need to know before networking your first Art-Net or sACN lighting devices! Beginner Level When looking to set up your first devices, networking can be a challenge when first starting out.
0 Comments
Leave a Reply. |